Myler 2-Ring Combination Bit MB 04

• Show Jumping
• Distance

The combination bit has a noseband and chin/jaw strap that applies pressure that the horse is familiar with from the halter. When you make contact on the bridle, these pressure points are the first to be affected - on the bridge of the nose, under the chin and in the neck. If the horse doesn't yield to this pressure, the mouthpiece on the bit will give a signal in the horse's mouth. The bit ring is equipped with a stop block, so initially the horse's mouth will only be minimally affected - if the horse does not relieve the pressure here, the block will activate the mouthpiece and put more signal in the horse's mouth.

The combination bit is available with different mouthpieces and different degrees of tongue freedom. In addition, Myler the combination bit is available with either two or three rings.

Thehorse at Level 2:

• The horse has the basic training and masters the basic signals (start, stop, turn).
• The horse begins to master more complicated exercises - for example, leg yielding.
• The horse has only been ridden a little, but has a good temperament.
• The horse shows resistance and reluctance to the Myler bites in Level 1.

Independent Side Movement

Some of the Myler bits are equipped with so-called "Independent Side Movement". This is, as the name indicates, allows the rider to move each side of the bit independently of each other. This means that when the rider pulls on one rein, the horse gets a very clear signal as only one side moves. This provides effective shoulder control and bending of the horse.